Try Design-Rules-Routing-Routing layers.

Dave

-----Original Message-----
From: Michael Reynolds [mailto:[EMAIL PROTECTED]]
Sent: 13 March 2001 16:04
To: 'Protel EDA Forum'
Subject: Re: [PEDA] auto-routing layers


Where is the layer setup in the DRC?  The only thing that I can think of is
that I routed (accidentally) with 2 signal layers.  When I realized that I
did not include the two mid layers, I went back into the Layer Stack Manager
and added 2 mid layers.  It shows up in the Layer Stack Manager but the
autorouter will not use them.

-----Original Message-----
From: Pierce, Scott [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, March 13, 2001 9:34 AM
To: '[EMAIL PROTECTED]'
Subject: [PEDA] auto-routing layers


Do you have your layers set-up in the DRC?

Scott
x 396



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to