I think it is maybe gone
fraught with pitfalls anyway if you move the board around on the
workspace, I remember getting burned on that once
Dennis Saputelli
Linden Doyle wrote:
>
> Greetings all,
>
> Has anyone had reason to use the REGION scope mentioned in the Design Rule
>section of the manual for PCB?
>
> I ask because I cannot find it within the program itself.
>
> What I am trying to do is set up an area on my PCB where clearance constraints
>can be relaxed. This area will be conformally coated thus reducing spacing
>requirements.
>
> The manual simply says to select region as one of the clearance scopes and a
>button will appear to allow definition of the region. Unfortunately its not that
>simple - REGION does not appear as one of the scope options.
>
> Any ideas on achieving what I'm trying to do (either using regions or in some
>other fashion)?
>
> Best Regards,
>
> LINDEN DOYLE
> Product Development Engineer
> Zener Electric Pty Ltd
>
> [EMAIL PROTECTED]
> Ph: +61 2 9795 3600
> Fax: +61 2 9795 3611
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *