You could find one pad of a component that is at fault, open the library
file and change the relevant properties of one pad of that device and
then use the "global" change command.
You can specify what properties to match and change in this screen.
All SMD pads should be plated, because Protel doesn't like it if not!!
Once you have updated all the pads of the component, by one simple
process, save the changes to the library, and then click the "update
PCB" button.
This will update all the pads for any of those components on your PCB,
providing the PCB file is open when you click the update button.
You can then do this for any offending components.

Steve

-----Original Message-----
From: Tommy Åkesson [mailto:[EMAIL PROTECTED]]
Sent: 13 August 2001 19:19
To: Protel EDA Forum
Subject: [PEDA] SV: SV: Unplated SMD-pads??


No cant find any. But if its a multilayer but not plated?. How can i
find
this?? Okej I know the hard way, click on every pad and check propertys.
This will take hours.

Tommy




-----Ursprungligt meddelande-----
Från: Bob Fearon [mailto:[EMAIL PROTECTED]]
Skickat: den 13 augusti 2001 18:02
Till: Protel EDA Forum
Ämne: Re: [PEDA] SV: Unplated SMD-pads??


They should show up on the screen as a different color ( multilayer
color) instead of top layer or bottom layer.


Tommy  kesson wrote:

> Okej, perhaps... But how do I find them?
>
> Tommy
>
> -----Ursprungligt meddelande-----
> Fr n: Bob Fearon [mailto:[EMAIL PROTECTED]]
> Skickat: den 13 augusti 2001 15:55
> Till: Protel EDA Forum
>  mne: Re: [PEDA] Unplated SMD-pads??
>
> Tommy
>     Do you have any of your SMD pads set as multilayer?
>     I have only seen this message when I made that mistake.
> Bob
>
> Tommy  kesson wrote:
>
> > Sometime then I do DRC I get an error message.
> > "Broken-nets contraint"
> > Net GND
> > Warning nets constain unpladet pads.
> >
> > How do I find this unplated pads!!!
> > Wy must SMD-pads bee plated!!!
> >
> > Any comments or suggestions??
> >
> > Regards
> > Tommy

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to