Hello Ivan,
Just hit the '*' key and then one left click to place the via.

regards,

Phil


Phil Dutton C.I.D.
Senior CAD Technician
IPC Certified Interconnect Designer

Tenix Defence Pty Ltd 
Electronic Systems Division
Second Avenue, Technology Park,
Mawson Lakes.  SOUTH AUSTRALIA  5095

================================
Phone   (08) 8300 4400 (reception)
        (08) 8300 4481 (direct)
Fax             (08) 8349 7420
email           [EMAIL PROTECTED]
Internet Page   http//www.tenix.com
================================


-----Original Message-----
From: Bagotronix Tech Support [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, 11 September 2001 8:22
To: Protel EDA Forum
Subject: [PEDA] 99SE manual routing problem


Hello, all:

When manually routing, the shortcut key '/' does not work.  Therefore, I
cannot place a via connecting to an internal plane.  Yes, I do have the
layer stackup with GND and VCC planes defined.  What gives?

Best regards,
Ivan Baggett
Bagotronix Inc.
website:  www.bagotronix.com



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to