*******************************************************
Todays forums are sponsored by Ian Martin Limited
Engineering/Technical Placement Specialists
www.ianmartin.com
*******************************************************

Found an unusual bug.... When generating the CAM files, I usually include
the BOM generation. I have a PCB without parts on it... it's a printed
spiral inductor. I ran the CAM files like usual, and the BOM utility would
not finish.... ran and ran and ran... Had to terminate Protel 99SE from the
Task Manager. My guess is, the BOM utility doesn't know how to deal with a
board with zero parts on it.  So it hangs... anyone else seen this?

Bill Brooks 
PCB Design Engineer , C.I.D.
DATRON WORLD COMMUNICATIONS, INC
3030 Enterprise Court 
Vista, CA 92083 
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 
mailto:[EMAIL PROTECTED] 
IPC Designers Council, San Diego Chapter 
http://www.ipc.org/SanDiego/
http://home.fda.net/bbrooks/pca/pca.htm

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to