*******************************************************
Todays forums are sponsored by Ian Martin Limited
Engineering/Technical Placement Specialists
www.ianmartin.com
*******************************************************


Hi Brian,

this will not be of much help for you, but consider like many of us
co-Protel-Users not to rely on Protel libraries, but to create your own.
You will have to check Protel library entries anyway and rework them
according to your needs.

Regards,

Gisbert Auge



                                                                                       
                       
                    [EMAIL PROTECTED]                                                      
                       
                    za                   An:     "Protel EDA Forum" 
<[EMAIL PROTECTED]>          
                                         Kopie:                                        
                       
                    03.10.2001           Thema:  [PEDA] Conflicting footprints and 
decals                     
                    09:42                                                              
                       
                    Bitte                                                              
                       
                    antworten an                                                       
                       
                    "Protel EDA                                                        
                       
                    Forum"                                                             
                       
                                                                                       
                       
                                                                                       
                       




Hi All,
May be I missed this thread, but needed to lay out a pcb with
amongst others two low power 5 volt regulators. In addition needed
a TO-247 footprint and opened the the Transistors.lib as well as
PCB Footprints.lib libraries.  If you browse the two libraries and
examine the TO92(A or B or C) in the Transistors.lib and the TO-
92(A or B) in the PCB Footprints.lib that positions of pad 1 are
reversed.
The same applies in the schematic libraries.  I selected a
LP2950CZ5.0 from the NSC Power Supply Circuit Library and a
Voltreg from the Miscellaneous library and the Input and Output
pins on the two decals are also reversed.  A good way to destroy
some regulators!
I am using Protel99SE /SP6
Thanks,
Brian
Brian Merskey
Institute for Maritime Technology
Phone: (2721)7861092
Fax:   (2721)7862189
E-mail:  [EMAIL PROTECTED]



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to