hello,

i've gone thru and hand-routed a 10-layer board from my protel
schematic and bad artwork of the original layers.  as suggested,
i set the design rules for un-routed traces and it pointed out a
few to me.

here's what i ran into:  i went to correct one of the unrun traces.
it appeared missing.  but when i selected interactive routing and
clicked on a pad, some other junk traces popped up on that 
layer.  it looked like maybe it had been good but that it had been
accidentally dragged.  it even illegally crossed other traces on the
layer.  so i go up and select edit/delete and the darn thing dis-
appears before i can delete it!  i finally kept it from disappearing
by turning all the layers back on, and then i deleted it.

could somebody explain what was going on there?  

thank you, miker

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to