Some time ago, I had trouble with a fuse value of 1A. This was interpreted
as a
HEX NUMBER means 26 or so. The work around was to name the fuse 1.0AMP.
Try if it works with different net names.

Georg

-----Urspr ngliche Nachricht-----
Von: Thomas [mailto:[EMAIL PROTECTED]]
Gesendet: Freitag, 16. November 2001 08:20
An: '[EMAIL PROTECTED]'
Betreff: [PEDA] Net class problems


I have a PCB in which two nets keep changing their net class.

The nets are AC1 and AC2, they should belong to a net class called LV.
However they keep changing to a class called HV (other members of this class
are A, N, C, NO, NC).

They seem to swap whenever I edit a primitive associated with AC1 or AC2.

There are no short circuits (DRC is ok if I move the nets to the correct
class then run DRC before doing any editing).

What is going on?

This PCB was a V3 file but has since been updated and saved as a 99SE (SP6)
v4 binary.




---------------------------------------
Powercom Consultants Pty Ltd
Electronics & Communications Engineers
PH +61 3 62297966  Fax +61 3 62299245
---------------------------------------

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to