OK

That works.
But my main problem that startet all this was:
When I pour polygon it pour all over the components, have checkt
" connect to net" "and remove dead cupper".
It did not do this in beginning of my work.

Any ideas??

Tanks
Tommy


-----Ursprungligt meddelande-----
Från: Amy Nolen [mailto:[EMAIL PROTECTED]]
Skickat: den 28 november 2001 17:21
Till: 'Protel EDA Forum'
Ämne: Re: [PEDA] Phatom polygons??


Hi Tommy,

I had that problem too. I closed all the files in that database including
the documents folder (only have the .ddb tab and .pcb tab showing) and then
try it again.

Thanks,
Amy Nolen
PCB Layout Technician
RF Micro Devices
7914 Piedmont Triad Parkway
Greensboro NC 27409
(336) 931-7099


-----Original Message-----
From: Tommy Åkesson [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 28, 2001 11:16 AM
To: Protel EDA Forum
Subject: [PEDA] Phatom polygons??


Hi
Having problems with invisible polygones.
Tryed out the Item 2434 in knowledge base.
But when changin layer in spread I get the message
"Sorry, board was not updated correcly"

Running 99 SE SP6

What to do??

Regards
Tommy

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to