If you have the option -remove dead copper- on & there is no access to the specified
pour over same net in the area where you wish to build this polygon.  This would in
fact start and seem to finish building the polygon, except it disappears right at the
end.

Also make sure your trace clearance gap rule is small enough so that a polygon can
actually be built.

____________
Brian Guralnick


----- Original Message -----
From: "Patrick Adair" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Wednesday, December 12, 2001 4:02 PM
Subject: Re: [PEDA] URGENT!!!


| Insure that polygons are not hidden under the show/hide options of the
| display.
|
| Patrick
|
| -----Original Message-----
| From: Narinder Kumar [mailto:[EMAIL PROTECTED]]
| Sent: Wednesday, December 12, 2001 2:45 PM
| To: Protel EDA Forum
| Subject: Re: [PEDA] URGENT!!!
|
|
| May be there is nothing to connect No pad ) on that net in that area.
|
| Narinder
| ----- Original Message -----
| From: "Sean James" <[EMAIL PROTECTED]>
| To: "Protel EDA Forum" <[EMAIL PROTECTED]>
| Sent: Wednesday, December 12, 2001 3:28 PM
| Subject: [PEDA] URGENT!!!
|
|
| What would keep a polygon pour from not forming if
| A. There are no keepouts.
| B. There are no areas present to create "dead" copper pours.
| C. I am pouring over the same net.
|
| Sean James
| PCB Designer
| Telecast Fiber Systems, Inc.
| 102 Grove Street
| Worcester, MA 01605
| (TEL) 508.754.4858 x33
| (FAX) 413.541.6170
|
|
|
|


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to