yep

-----Original Message-----
From: Mark E Witherite [mailto:[EMAIL PROTECTED]]
Sent: Thursday, January 24, 2002 4:45 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Autoroute error message


Do you have any arcs in your keep out layer?

At 02:13 PM 1/24/02 -0600, you wrote:
>I know I have seen this error before but I can't remember how to fix it.
>When I try to start the autorouter it tells me that one or more connections
>cannot be routed due to design rule violations. I have checked the border
of
>the board and it is fine there are no gaps and the outline is on the
keepout
>layer. I haven't seen this in a long time and am at a loss to figure it
out.
>Any help would be appreciated.
>Nick Cobb
>

Mark Witherite  C.I.D.
Assistant Research Engineer
Astronomy & Astrophysics
Penn State University
2565 Park Center Blvd
Suite 200
State College, PA.  16801
email [EMAIL PROTECTED]
telephone 814 865 9839
fax           814 865 9100



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to