draft mode can be pretty useful at times, it shows scraps, schmootz, and
vertice locations
i think Dan would like it to work other than the way it does

Dennis Saputelli

Brad Velander wrote:
> 
> Isn't this the third time that this exact message has been posted? I note
> that the date on the message is Feb 1st 2002, is Techserv reposting this
> message on some sort of scheduled release?
> 
> I seem to remember that someone had previously responded to this enquiry as
> well.
> 
> I have never used draft mode so I certainly have nothing to say, other then
> it sounds like a typical "Protelism".
> 
> Sincerely,
> Brad Velander.
> 
> Lead PCB Designer
> Norsat International Inc.
> Microwave Products
> Tel   (604) 292-9089 (direct line)
> Fax  (604) 292-9010
> email: [EMAIL PROTECTED]
> http://www.norsat.com
> 
> See us at Booth 323 at Satellite 2002 in Washington, DC March 6-8.
> 
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]
> Sent: Friday, February 01, 2002 6:05 AM
> To: proteledaforum
> Subject: [PEDA] PCB: DRAFT mode and PUSH obstacle
> 
> Hello,
> 
> I set tracks/vias/pads to DRAFT mode in the PCB editor.  When I'm in push
> obstacle mode, if it shoves a track to far, to be a violation, it turns
> green.  So far so good.  When I move it back, it turns back to the color,
> but in FINAL mode, not DRAFT mode.  Same for pads and vias.  Is there
> something I can configure to change this?  It's pretty annoying the way it
> is now.
> 
> Thanks,
> 
> Dan

-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to