The protel related advice is short. switch all routing layers except the bottom layer off. Make some parts for jumper wire. ( Not any size but a few ). Add teardrops, use not less than pad - hole shoud be not less than 0.8mm. Tracks should be not smaller than 0.5mm. Holes should be very thight to the component pins. need lots of different. ). aso.
---------- But the rest. Are you thinking of a stamped board made from FR2 ? Tell us more about the project. Every project of this kind I know from ended in a more or less big catastrophe. Georg -----Urspr ngliche Nachricht----- Von: skywalker [mailto:[EMAIL PROTECTED]] Gesendet: Montag, 11. M rz 2002 03:13 An: Protel EDA Forum Betreff: [PEDA] Single Sided PCB Can anyone tell me how to do a single sided pcb in protel 99se????? Raybo * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
