Hello all,
        Currently on PCB's I flood the top and bottom layers with a ground plane
after routing.  I have it remove the dead copper then I manually place via's
where there was no flood to connect those area's to ground.  I then repour
the planes and continue this process until I am satisfied with the coverage.
This can't be the most efficient way.  Is anyone else doing something like
this that has a better way or a trick I am unaware of?  I look forward to
reading your replies.

Afshin Salehi
DPS Telecom


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to