03/09/2002 10:52:41, "Schmitt Michael" <[EMAIL PROTECTED]> wrote:
>Image a track surrounded by a polygon. The track has a 45 degree corner. on >the outter side protel(as seen in draft mode) places a short ARC at the >corner, but in GERBER (as seen by camtastic) there is a track connected from >and to the points where the arc should be. In the CAM manager, gerber setup, advanced, there's "use software arcs". This check-box would be better labelled "don't screw up arcs". I don't know iif the gerber contains arcs, or a collection of really small tracks when this is checked, but it does at least do what you expect, and the gerbers are good... I've not turned it off since I discovered it. Naturally, it defaults to off... It may well be that the gerbers are OK, but the gerber plotter and viewer are wrong - I didn't investigate further, once I stopped the symptoms. Hope that helps. (I needed it to solve inside-out arcs, but odds on, it'll get rid of your problems too) Steve ************************************************************************ * Tracking #: E9CB64D04FACF74D86AB5A6DB37F7407F24AD1CC * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
