Anand Kulkarni wrote:

> Hi everyone ,
> I am trying to manually route a 6 layer board .
> Right now I have the components that I need to route on the board.
> I started to use the interactive routing mode;
> bu twhen I press the '*' key to change layers instead of a via I get a crash that 
>advises me to exit the application.
> Anybody have a clue about what might be causing this.
> 
> please do reply with you suggestions
> 

Just a shot - do you have your signal layers turned on?
It has been reported some time ago by Terry Creer that hitting '*' key
when there are no signal layers enabled may cause a crash.
It doesn't happen on all systems.

Wojciech Oborski

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to