Hello,

No, there is no automated way within Protel.
I usually do a manual scan with just the copper layer, solder mask and overlay turned 
on.
I also include a note on the master (fab) drawing allowing the cropping of legend 
0.010" from solderable pads.
As has been mentioned, most shops do this anyway as a matter of process.

regards,

Phil.


----- Original Message -----
From: "Rich Thompson" <[EMAIL PROTECTED]>
To: "'Protel EDA Forum'" <[EMAIL PROTECTED]>
Sent: Thursday, October 31, 2002 5:01 AM
Subject: [PEDA] Silkscreen over pads


> Hi
>
> I sometimes miss silkscreen printed over component pads, is there a rule
> to look for this in 99SEsp6?
>
> Thanks
>
> Rich
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:proteledaforum@;techservinc.com
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:ForumAdministrator@;TechServInc.com
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@;techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to