ok, I checked the "redraw layers" box. That fixes #1....

TIm

-----Original Message-----
From: Dennis Saputelli [mailto:dsicon@;integratedcontrolsinc.com]
Sent: Friday, November 15, 2002 1:08 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Screen Refresh


i think that sounds pretty normal
(hitting END a lot)

have you checked the 'clean redraw' box?

Dennis Saputelli

Tim Fifield wrote:
>
> Just wondering if the following is normal or if something weird is going
> on.... (P99SE, SP6, W2K)
>
> 1. When toggling through layers with the +/- keys or clicking on the layer
> tab with my cursor I must press the END key in order to refresh my screen
to
> see the layer that I have just selected.
>
> 2. When moving a Ref Des with my cursor AND I hold down the CTRL key, so
as
> to not snap to any near by objects (i.e. the little lines in a polygon
> plane) the ref des, part, and all surrounding circuitry disappears. It
looks
> like a small rectangle hole in the board. I can see the grid. I must press
> END to refresh the screen to bring the part back. It doesn't do this when
I
> hold down the CTRL key.
>
> Does this happen to anybody else? I guess I've just gotten used to
pressing
> the end key a lot. But it would be nice if I didn't have to.
> Tim Fifield
>

--
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.
   tel: 415-647-0480                        2851 21st Street
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:proteledaforum@;techservinc.com
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:ForumAdministrator@;TechServInc.com
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@;techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to