Can anyone offer any suggestions on what I've broken? Up until about 20 minutes ago, whenever I had the power planes (COM and 5V/3.3V split) displayed I could see the blowouts around the pads and vias that did not connect to these planes.
I wrote a design rule to allow direct connection of vias to the planes as they appeared as relief connections by default. This seemed to work for a time but now I dont see any of the blowouts. I'm not sure if I've broken the display of the blowouts or the blowout spec itself such thet they are now too small to display. Any ideas anyone? Best Regards, Linden Doyle Product Development Engineer Zener Electric Pty Ltd. Ph: +61 2 9795 3600 Fax: +61 2 9795 3611 [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
