Hi Linden Take a look at you design rules you may have entered a plane expansion in imperial instead of metric. ie. 0.2 thou instead of 0.2mm.
Joe ----- Original Message ----- From: "Linden Doyle" <[EMAIL PROTECTED]> To: "PEDA" <[EMAIL PROTECTED]> Sent: Thursday, June 05, 2003 11:44 AM Subject: [PEDA] Invisible power plane blowouts > Can anyone offer any suggestions on what I've broken? > > Up until about 20 minutes ago, whenever I had the power planes (COM and > 5V/3.3V split) displayed I could see the blowouts around the pads and vias > that did not connect to these planes. > > I wrote a design rule to allow direct connection of vias to the planes as > they appeared as relief connections by default. > > This seemed to work for a time but now I dont see any of the blowouts. I'm > not sure if I've broken the display of the blowouts or the blowout spec > itself such thet they are now too small to display. > > Any ideas anyone? > > > Best Regards, > > Linden Doyle > Product Development Engineer > Zener Electric Pty Ltd. > > Ph: +61 2 9795 3600 > Fax: +61 2 9795 3611 > [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *