Hi all,
        I've just been handed a rather large board with quite a few
individual GND polygons on it (35 to be exact). I've been asked to clean it
up so we can have a prototype made. Every time I make a change to the board,
(ie, move track, delete fill etc..etc..), after the edit, it sits there for
about 6 seconds with " Analysing GND" in the status bar at the bottom, and
then all is well until the next edit. 
        I've turned off all online DRC checks, and anything else I could
think of, to no avail. I'm pulling my hair out trying to get this done (and
there's a lot to do...).

Any ideas?

Thanks!

TC


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to