Can any one address autoplace settings and/or required rules for a successful 
autoplacement of a dense population of components on a small footprint. I am having 
issues with components stacking on each other and/or placing outside boundaries. Any 
help will be greatly appreciated.

Thank you,



Tom Sprunger
Product Design/
PCB Designer
CTS Resistor/Electro
406 Parr Road
Berne, IN 46711
(260)589-7191
Fax: (260)589-7591


===================================================================
Notice:  This message is intended solely for the person to whom it
is addressed.  Unintended recipients will be legally responsible for
unauthorized use, disclosure, copying or distribution.  If you have
received this message in error, please notify the sender immediately
by replying to this message.  Then delete this message from your
system.  Thank you.

CTS Resistor/Electrocomponents          (260) 589-3111 Phone
406 Parr Road                           (260) 589-3243 Fax
Berne, IN 46711                         www.ctscorp.com

===================================================================


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to