Yes, I refer the PAD and eletronic workbench. PAD for board layout EB for simulation.
-----Original Message----- From: Chacon Simon, Geoffrey [mailto:[EMAIL PROTECTED] Sent: Thursday, October 30, 2003 7:38 AM To: [EMAIL PROTECTED] Subject: [PEDA] Protel vs Electronic Workbench vs PADS Hi everybody, In my department we are going to buy an ECAD software to support several projects that require from only simulations to full level board design up to using FPGA. I have use Protel before and I think it's an excellent design platform. My boss wants me to recommend between Protel and EW, and I found that EW is still a young platform and lacks several Protel's features. However, I may be blind since I used Protel extensively before, so I would like someone else's opinion about that decision. I was also considering PADS, which seems to have good features that protel lacks, but I don't know if its cost is way beyond Protel's. I appreciate any comments about these programs. Thanks in advance, Geoffrey * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
