Hi Everyone,
I've been using Protel 98SE and 99 on and off for years, but this is the first time in awhile, and the first time with DXP, so I'm really rusty. Is there a way to reduce the font size in pin descriptions? I've got a part that nearly fills a B sized sheet once I've put "logical" names on the pins and spread everything out so it's legible. It would be nice if I could shrink it enough to draw a schematic around it ;) Thanks, -- Mark Randol, Engineer Intel Corporation, MS CH6-451, 5000 W Chandler Blvd, Chandler, AZ 85226 480-554-3025 (voice), 480-552-8946 (FAX) [EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
