Yes Jeff what most of us do is run an ERC(electrical Rules Check), it is evoked under the tools dropdown




----- Original Message ----- From: "Jeff Condit" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 07, 2004 12:46 PM
Subject: [PEDA] Unconnected Ports



In Protel 99SE Schematic, a couple ports were positioned a few thousandths of an inch away from a wire and hence made no connection. This made the pins not get included in the netlist. The distance was too small to see in a quick visual check. Is there a way to quickly mark and find unconnected wire ends?


Jeff Condit

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * *





* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to