Dennis,

I agree if the ports don't get a name aka netlist hookup the ERC won't flag them, in that case it should flag the wire, for me it's usually the furthest end away from where I'm working, Jeff never specified

Joe


----- Original Message ----- From: "Dennis Saputelli" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 07, 2004 5:14 PM
Subject: Re: [PEDA] Unconnected Ports



JOE
the ERC will not flag PORTS (AFAIK)
power ports and other stuff yes

it is interesting that it really doesn't want to let you place a port
unless it is going to be connected

you can trick it or move it later but try to just place one in the air,
it will erase it automatically if it was not at least initially connected

Dennis Saputelli


Joe Sapienza wrote:

Yes Jeff what most of us do is run an ERC(electrical Rules Check), it is evoked under the tools dropdown

----- Original Message -----
From: "Jeff Condit" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 07, 2004 12:46 PM
Subject: [PEDA] Unconnected Ports

In Protel 99SE Schematic, a couple ports were positioned a few thousandths
of an inch away from a wire and hence made no connection. This made the
pins not get included in the netlist. The distance was too small to see in
a quick visual check. Is there a way to quickly mark and find unconnected
wire ends?


Jeff Condit


-- _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to