When I boot my freescale iMX28 board without an ethernet cable, it waits just after ADDRCONF: link is not ready. When I plug in an ethernet cable, booting resumes.
[ 2.320000] eth0: Freescale FEC PHY driver [SMSC LAN8710/LAN8720] (mii_bus:phy_addr=imx28-fec-1:00, irq=-1) [ 2.330000] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 11.320000] PHY: imx28-fec-1:00 - Link is Up - 100/Full [ 11.340000] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 11.360000] IP-Config: Complete: Why does the boot process wait for an ethernet cable? Is there a timeout that can be configured (so the boot process can resume faster)? Thanks! -- ptxdist mailing list [email protected]
