On Thu, Oct 04, 2012 at 01:53:53PM +0000, Johannes De Smedt wrote: > When I boot my freescale iMX28 board without an ethernet cable, it waits just > after ADDRCONF: link is not ready. When I plug in an ethernet cable, booting > resumes. > > [ 2.320000] eth0: Freescale FEC PHY driver [SMSC LAN8710/LAN8720] > (mii_bus:phy_addr=imx28-fec-1:00, irq=-1) > [ 2.330000] ADDRCONF(NETDEV_UP): eth0: link is not ready > [ 11.320000] PHY: imx28-fec-1:00 - Link is Up - 100/Full > [ 11.340000] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready > [ 11.360000] IP-Config: Complete: > > Why does the boot process wait for an ethernet cable? Is there a timeout that > can > be configured (so the boot process can resume faster)?
This looks like a kernel issue, not a ptxdist issue. So this is the wrong mailing list. rsc -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | -- ptxdist mailing list [email protected]
