https://bugs.freedesktop.org/show_bug.cgi?id=39664
--- Comment #4 from Antonio Ospite <[email protected]> 2011-08-04 04:49:07 PDT --- (In reply to comment #3) > Hi Antonio, > > Thanks for the bug report. > > Would it be possible to get us a better log from PA. The details in the syslog > are pretty sparse, so if you could disable autospawning via: "echo > autospawn=no > >>~/.pulse/client.conf" and then run PA manually on the command line via > "pulseaudio -vvvvv" then it should give you a lot more info which could help. > OK, full log attached in 'pulseaudio_verbose_kinect_NOT_detected.txt' you can skip to when I plug in the device by going to line 1018 "ABOUT TO PLUG IN THE Kinect", and the tentative detection is until line 4223 "NOT DETECTED" I noticed that if the device is _already_ plugged in when pulseaudio starts, then it gets recognized automatically, it looks like this happens because the Kinect is detected _before_ the other soundcard in the system, this seems to be confirmed by the "pacmd ls" output from below. I am attaching also the log for this case, see 'pulseaudio_verbose_kinect_detected_first.txt'. I tried to compare the failure with the success to narrow down the cause but I can't figure it out yet. > I suspect that the trick here will be to write a specific profile for this > device (it's quite specialised after all) which will then be able to give the > right names to the devices. Note however, that our channel names are > relatively > fixed (they have to be so that sounds can be mapped to channels properly) and > thus you may not be able to get the perfect names here. > > > http://pulseaudio.org/wiki/WritingProfiles > OK, I can look into this later can't I? The misnaming is not related to the failed detection I suppose. > In addition to the the debug output please also supply: > > 1. amixer -c1 (where 1 is the card number - cat /proc/adound/cards) > 2. pacmd ls (when the device is working properly - perhaps after restarting > PA) 1. amixer shows nothing, no controls at all: $ cat /proc/asound/cards 0 [NVidia ]: HDA-Intel - HDA NVidia HDA NVidia at 0xfcf78000 irq 20 1 [Audio ]: USB-Audio - Kinect USB Audio Microsoft Kinect USB Audio at usb-0000:00:02.1-5.1, high speed $ amixer -c1 $ 2. output from "pacmd ls" is attached, when the Kinect is recognized it shows up as the first sourdcard to pulseaudio, see from line 525. > Note that even when PA is restarted, udev is used to detect things. I suspect > the problem of it not showing up is related to some kind of race condition. > Thanks, Antonio -- Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the QA contact for the bug. You are the assignee for the bug. _______________________________________________ pulseaudio-bugs mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/pulseaudio-bugs
