https://bugs.freedesktop.org/show_bug.cgi?id=39664
--- Comment #8 from Antonio Ospite <[email protected]> 2011-09-07 13:43:10 PDT --- OK, with the attached profile (kinect-audio.conf) and the proper udev rules (55-kinect_audio.rules, using Drew's upload_fw), I have the device working fine even when plugged _after_ pulseaudio has started. The profile is very simple it just defines a 4 channels, input-only mapping on hw:%f. Can this help you to understand what the cause of the original failure with default.conf is? I found a possible cure, but I am still not sure about what the cause of the problem was. Is there still room for improvement about the channels names? I mean, am I forced to use fixed names ( front-left, front-right, rear-left, rear-right), or can I use something like Mic1, Mic2, Mic3, Mic4? Regards, Antonio Ospite http://ao2.it -- Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the QA contact for the bug. You are the assignee for the bug. _______________________________________________ pulseaudio-bugs mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/pulseaudio-bugs
