How about using the rig in a scene set to cm, and post-compensate scale globally either during or after export? If the rig must be used in a scene with an environment, would it be possible to scale the environment to compensate during animation? I've had good experiences with controlled compensation like these in cases where there was either little control on one end (such as being a cloth artist working with an oversized animation rig), or when a significant development effort was required to conform one to the other (as in your case).
> On 27 Apr 2015, at 20:57, Mark Jackson <[email protected]> wrote: > > So we have a carefully setup facial control board setup in cm's but needs to > run it in a client scene set in meters, no problem right? Unfortunately > because all the sliders are carefully setup with limits on the transforms of > 0-1 when the scene comes into Maya in meters, all those transforms are > recalculated and reset to 0.01, including all the transform limits. > > All reasonable I guess, question is, is there a fast painless way of > re-building or adjusting the rig to work with the new units yet still retain > all of it's original transforms and limits? > > Even if I scale, reset the limits and get it so that the transforms are > driving 0-1 the final output node, which all the sliders drive, ends up with > values of 100 unless I then disconnect all the final output values and force > a unitConversion node in there too. > > Must surely be a better way, been a long day! > > thanks > > Mark > > > > > ------------------------------------- > Mark Jackson > CEO / Technical Director > red9consultancy.com > -- > You received this message because you are subscribed to the Google Groups > "Python Programming for Autodesk Maya" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/python_inside_maya/CAGQH2FGXCAZ30MqmZsSOC%2Bw3HSeqZyJscBQcOMymZtjCKuYUmg%40mail.gmail.com. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Python Programming for Autodesk Maya" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/python_inside_maya/0AFA089A-9984-4C73-9487-4A859061D8CD%40gmail.com. For more options, visit https://groups.google.com/d/optout.
