On 05/23/18 01:40, Michael S. Tsirkin wrote: > On Wed, May 23, 2018 at 12:42:09AM +0200, Laszlo Ersek wrote: >> Hold on, >> >> On 05/22/18 21:51, Laszlo Ersek wrote: >> >>> It had taken years until the edk2 core gained a universal >>> PciHostBridgeDxe driver with a well-defined platform customization >>> interface, and that interface doesn't support multiple domains / >>> segments. >> >> after doing a bit more research: I was wrong about this. What I >> remembered was not the current state. Edk2 does seem to support multiple >> domains, with different segment numbers, ECAM base addresses, and bus >> number ranges. If we figure out a placement strategy or an easy to >> consume representation of these data for the firmware, it might be >> possible for OVMF to hook them into the edk2 core (although not in the >> earliest firmware phases, such as SEC and PEI). >> >> In retrospect, I'm honestly surprised that so much multi-segment support >> has been upstreamed to the edk2 core. Sorry about the FUD. (My general >> points remain valid, for the record... But perhaps they no longer matter >> for this discussion.) >> >> (I meant to send this message soon after >> <fc603491-7c41-e862-a583-2bae6f165b5a@redhat.com">http://mid.mail-archive.com/fc603491-7c41-e862-a583-2bae6f165b5a@redhat.com>, >> but my internet connection had to die right then.) >> >> Thanks >> Laszlo > > Is there support for any hardware which we could emulate?
I don't see any actual hw support in the edk2 project, but I'll ask. Thanks Laszlo