Dilwyn, If you have a CD, put it in drive, if it does not autostart, click Start, then Run, and browse. From the Dir that comes up select setup, or boot, or install, whatever the .exe file is, and it should install itself. Regards
Mike MacNamara [EMAIL PROTECTED] ----- Original Message ----- From: "Dilwyn Jones" <[EMAIL PROTECTED]> To: "QL Users List" <[EMAIL PROTECTED]> Sent: Tuesday, April 06, 2004 8:47 PM Subject: Re: [ql-users] Printer help > > Click on 'View devices by connection'. Highlight the device, and > view > > its Properties. > > > > If they make sense it is OK. If not try an 'automatic' install, or > if > > that fails a manual install. Then delete any unwanted versions, as > you > > could end up with several - that is, if you haven't already :-) ? > I did. A partial installation is actually a full installation it > seems, but a non-working installation defaulting to all sorts of wrong > defaults. Uninstall clears it, but next time you try to install it > goes back to the same useless defaults. It only seems to clear to > clean machine status by finding epson's .inf file for the printer. > Even though the software's been uninstalled, Windows seems to remember > what and where the driver was so the only way to make it forget is to > find and delete this .inf file. > > To test if it's the onboard USB I've ordered a cheap USB-PCI card. > Only two sockets on it, and it only costs about a fiver, so if that > works I'll know the onboard USB needs to go to hospital. > > > Paah, Windoze :-( > > > _______________________________________________ > QL-Users Mailing List _______________________________________________ QL-Users Mailing List
