On 23/04/2018 09:57, Bob Spelten via Ql-Users wrote:
Op Sun, 22 Apr 2018 18:00:20 +0200 schreef RWAP Software via Ql-Users
On QPC2 v4.04 here I didn't have to close anything - I just entered the
two commands above as soon as it started
Does anyone know why the following in QPC2 reports "Invalid Channel ID"
In fact, any attempt to change #1 after the WINDOW command reports an
Tested on a bare QPC2v404, this could happen if channel #1 is closed.
The WINDOW command does then not produce an error on the default
channel, which will be #0 now, but the PAPER #1 command does.
As stated, this does not happen in v4.05 so there must be something
which has been altered
Specialist Enuuk Auction Programming Services
QL-Users Mailing List