Hi,
I have checked the CDRom and it is configured as
a slave.
I had the the ATAPIqlub_bin and CDRom_bin
lrespr'd as you have said.
Both of those files are listed in the window on
boot up.
the boot file stops at cdr_drive 1,1,1 with the
error message.
I notice the CDR_ is included in the files
menu.
I have read the hard drive and it lists the CDROM
model as no 2 drive but it shows it as empty.
I do not know what version of Qcdeze I have
as I cannot find the version no.
I cannot email you privately as have not got your
address
The CDrom should be ok as it was one I was using
in a PC.It lights up on boot up when it is being read by the hard drive, but
that is all.
Aurora/SGC/:Superhermes/Smsqe v2.90/Qubide
2.10
Arnie
Hi,
To
start with the hardware:
have you configured jumpers on the CDRom drive to be the slave
drive with the hard disk configured as the
master
then
onto the software:
have LRESPRed both the ATAPIqub_bin & the CDROM_bin in
that order, both are needed.
CDR_DRIVE 1,1,1 is correct for the setup with the CDROM as slave and
hard disk as master.
Next
configuration of the ATAPI drivers with menuconfig. These need to be
configured for the IDE registers base address.
I
use 4FFF00 which I think is the default, may be not as I remember playing
about with it.
Thats all the setup. It works for me. My system is Aurora SuperGoldcard
SMSQ/E2.89 Qubide 2.01 hardisk as master and cheap 52xCDROM as
slave.
If
you have the same setup then your CDROM drive may be faulty. It would then be
worth while trying another.
If
you want I can send you the latest version of QCDEZE which is at 1.07c. email
me privately if you would like it.
Duncan
