The only problem per se is that your cpu is running constantly, and slowing everything down considerably.
Did that clamav come back after you rebooted? If so I guess you'll need to upgrade clamav-toaster, even though you're not actually using it. I'm not sure what exactly is wrong with that version that causes clamav to eat the cpu. Upgrading is a lot simpler than trying to remove clamav entirely. senthil vel wrote: > Thanks Eric, > after editing the /var/qmail/control/simcontrol as follows, > > :clam=no,spam=no,spam_hits=12,attach=.mp3:.src:.bat:.pif > > The mails are going out without any problem. I checked both from > webinterface and outlook. But the server load is > > load average: 1.01, 1.03, 0.85 > > Cpu(s): 99.3% us, 0.3% sy, 0.0% ni, 0.0% id, 0.0% wa, 0.3% hi, 0.0% si > Mem: 514400k total, 285764k used, 228636k free, 11944k buffers > Swap: 779144k total, 0k used, 779144k free, 99076k cached > > For an uptime 'up 26 min' > > PID USER PR NI VIRT RES SHR S %CPU %MEM TIME+ COMMAND > 2576 clamav 25 0 51748 45m 1268 R 99.9 9.0 2 > 6:17.64 clamd > > Will it cause some problem in long run? > > > Thanks and Regards, > S.Senthilvel, > > > > > On Sat, Aug 9, 2008 at 8:38 PM, senthil vel <[EMAIL PROTECTED]> wrote: >> The big problem is when we are sending mail through the webinter face, >> (nuts mail), It is telling that >> >> Requested action aborted: error in processing >> Server replied: 451 mail server temporarily rejected message (#4.3.0) >> >> Is the problem is with clam and spam or something else...? >> >> Thanks in advance, >> S.Senthilvel, >> >> >> >> >> >> On Sat, Aug 9, 2008 at 8:33 PM, Eric Shubert <[EMAIL PROTECTED]> wrote: >>> senthil vel wrote: >>>> Dear List, >>>> I am having a server in which Qmtiso 1.4.0 is installed. In >>>> this version of iso, the clamd and spamassassin-toaster are out dated. >>>> I am having a Spamtitan server which filters all mails to my qmail >>>> server. So i dont need the clamd and spamassassin-toaster to filter my >>>> mails. Is there any way to stop these two. Because clamd is taking >>>> 100% of cpu. Some times server is not accepting tha mails to send. But >>>> the ports 587 and 110 are open. >>>> >>>> I am attaching the setup of the servers with this mail. >>>> >>>> >>>> Thanks and Regards, >>>> S.Senthilvel, >>>> >>>> >>> Modify settings in /var/qmail/control/simcontrol appropriately (change "yes" >>> to "no"), then run >>> # qmailctl cdb >>> >>> You might need to kill a clamd process that doesn't terminate. I'm not sure >>> about that. >>> >>> -- >>> -Eric 'shubes' >>> -- -Eric 'shubes' --------------------------------------------------------------------- QmailToaster hosted by: VR Hosted <http://www.vr.org> --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]