Hi Houcheng, On Tue, Nov 04, 2014 at 09:48:56PM -0800, Houcheng Lin wrote: > Hi all, > > My systray didn't work in Ubuntu 12.10. I had tried every different > configuration for systray but
Support for 12.10 was EOL'd in May 2014; if that's not a typo, you can upgrade to 14.04 and use the stock xpyb packages from the distro, as the versions are new enough. Tycho > it just didn't show and no any error message on my system. I guess that I > had upgrade some of > the qtile depdent library that cause the problem. > So, i decided to upgrade all the library used by qtile and hope can fix the > problem. > After building several library and reboot, the qtile's systray shows two > lovely icons: DROPBOX > status and SKYPE notification. > > Below is a rough summary of steps to rebuild whole library, and BTW the ARM > platfrom can also > use these steps to build ARM version libraries. > > thanks, > Houcheng Lin > > > # install qtile to prevent missing > sudo apt-add-repository ppa:tycho-s/ppa > sudo apt-get update > sudo apt-get install qtile > > > mkdir qtile > cd qtile > > > # arm version qtile install #### > apt-get install autoconf libtool git > apt-get install python-dev libpng-dev python-gtk2 > > wget http://xcb.freedesktop.org/dist/xcb-proto-1.11.tar.gz > tar xzvf xcb-proto-1.10.tar.gz > cd xcb-proto-1.10.tar.gz > ./autogen.sh && ./configure && make install > cd .. > > > wget http://xcb.freedesktop.org/dist/xpyb-1.3.1.tar.gz > tar xzvf xpyb-1.3.1.tar.gz > cd xpyb-1.3.1 > libtoolize --force > aclocal > autoheader > automake --force-missing --add-missing > autoconf > ./configure > make install > cd .. > > > git clone [email protected]:tych0/xpyb-ng.git > cd xpyb-ng > python setup.py install > cd .. > > > # libxcb > wget http://xcb.freedesktop.org/dist/libxcb-1.11.tar.gz > tar xzvf libxcb-1.11.tar.gz > cd libxcb-1.11 > ./configure > make install > cd .. > > # pixman > git clone git://anongit.freedesktop.org/git/pixman.git > cd pixman > ./autogen.sh && make install -j3 > cd .. > > #cairo > wget http://cairographics.org/releases/cairo-1.10.0.tar.gz > tar xvzf cairo-1.10.0.tar.gz > cd cairo-1.10.0 > ./autogen.sh --enable-xcb > make > sudo make install > cd .. > > > git clone git://git.cairographics.org/git/py2cairo > cd py2cairo > ./autogen.sh --enable-xcb && make install > cd .. > > apt-get install python-gtk2 > > git clone git://github.com/qtile/qtile.git > cd qtile > sudo python setup.py install > > > -- > You received this message because you are subscribed to the Google Groups > "qtile-dev" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "qtile-dev" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
