yes i sit up front & no i don't get locked in. i have straps to secure the chair but don't use them, just use the seat belt. i've thought about getting an e-z lock but haven't.
Eric W Rudd [email protected] ----- Original Message ----- From: Mike Murach To: 'Eric W Rudd' ; [email protected] Sent: Monday, November 30, 2009 10:54 AM Subject: RE: [QUAD-L] information about mini vans versus full size and wheelchair Eric, do you sit up front? Do you have a lock down system? Mike~ -----Original Message----- From: Eric W Rudd [mailto:[email protected]] Sent: Monday, November 30, 2009 10:48 AM To: [email protected] Subject: Re: [QUAD-L] information about mini vans versus full size and wheelchair I have had www.entervan.com for years & my next one will be the same. I too am in a permobil & don't drive. Eric W Rudd [email protected] ----- Original Message ----- From: [email protected] To: [email protected] Sent: Monday, November 30, 2009 9:11 AM Subject: [QUAD-L] information about mini vans versus full size and wheelchair Hi Gang, What kind of vans do you use. I have always used a full size vehicle and I went to a united access location just to try out minivans during the summer. It seemed like there was so little room with my Permobile. My new chair has two wheels in front, which make the base a little longer. It was such a tight fit I was told that I would have to remove the front chair. I don't drive. Do any of you use the easy lock to secure your chair? are there others that are better? I'd like to know others experiences with both size and what vehicle models you prefer in both sizes. I will probably not be getting a brand-new, because of the cost. I'd also like to know the durability and problems that you have experienced. Have any of you purchased a vehicle and then had it modified. I use pencils with rubber in my splints. I am not able to reach the switches to control the functions at all and I have much difficulty reaching the mode button. Do any of you have problems reaching the switches? I I could use the switches and the mode button on my older model. Recently I wrote about my wheelchair going dead. I found out from the technician there is a connection under the arm that is a design flaw that is not in my other chair that attaches and can easily become pulled out. I was told it has to be connected with electrical tape or twist ties to prevent this problem.. Thank you and I appreciate any ideas or suggestions any of you may be able to offer with any of my questions. Dana .
