I recall demon tweeks did an off the shelf external swirl pot and possibly pump. It wasn't too expensive at around 100 pounds.
If I was going to injection again from scratch I would certainly think about this route. You do need two pumps but i'm sure it could look quite neat in the boot or similar. Matthew -----Original Message----- From: Arn1905 <[email protected]> Sent: 18 May 2009 22:34 To: Quantum Owners Group <[email protected]> Subject: [Quantum Owners] Re: injection tank thank you. my search will continue. On May 18, 10:20 pm, Jim Hearne <[email protected]> wrote: > No, not without modifications which would mean welding. > Even then i'm not certain if the fuel pump is the same as the CFI system > uses a lot lower fuel pressure than the port injection. > > Jim > > Arn1905 wrote: > > hi, > > Just a small question to ask, will a CFi engined 1994 1300 HCS Ghia > > fuel tank fit and be compatible with an rs turbo engined 2+2? > > > Thank you --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). -~----------~----~----~----~------~----~------~--~---
