> The problem with fitting the centre 3 point harness is getting the top
> centre seat belt mounted well enough, i don't think using the parcel
> shelf would be strong enough.
>
> Jim
I also had to remount the rear seat catches but installed a square
section steel across from one side of the car to the other under the
leading edge of the parcel shelf. I did this to add a bit of support
to the shelf and the seat latches, however there should be no issues
with increasing the size of the steel to be able to bolt a seat belt
to it but it would mean that the shoulder strap would be very low
unless you added a pedesal to the top of the shelf, then that would be
in the rear view mirror all the time.
Alternatively I suppose you could add a steel across the roof from
side to side and cover this with the headlining and have your top
mount on that.
Personally I would be happy for two proper belts and a lap belt for
the one in the middle for the number of times that you will probably
have the car full of people, and drive with more care when full.
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners
Club nor the individuals associated with the Quantum Owners Club or in the
preparation of the above information shall have any liability to any person or
entity with respect to liability, loss, or damage caused or alleged to be
caused directly or indirectly by the instructions contained within this or
related message(s).
-~----------~----~----~----~------~----~------~--~---
