> > > > > > On Tuesday 08 Dec 2009, Stuart Carvell wrote: > > > > > >> Probably a stupid question but, > > >> > > >> Which direction do you turn a tap? > > >> > > >> Need to rethread my rear axle > > >> > > >> Thanks > > >> > > >> Stuart > > >>
When you cut a thread, you're supposed to go so far in one direction, then back again to break off the metal you've just cut. This both improves the thread, and protects the die/tap from damage due to clogging up. Actual recommendations vary from person to person. I usually go 1 turn forward, then back 1/2 turn, then forward 1 turn, then back 1/2 turn..... On the back turn, you can often hear/feel the metal breaking away. A few drops of thread cutting oil every now and again is advised too; it really improves the finished thread and makes your cutting tool last longer. -- Tony Vincent -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
