Hiya Also make sure you don't bottom the tool out - they are brittle, and it *will* break.
How I was taught was to use a shallow tap, with only a small cutting surface (very chamfered), then the medium tap, then the final tap. What I did was to measure the depth with a suitable rod (inner of a ballpoint pen is normally god, then put some masking tape around the tap that far from the end to ensure you don't cut too deep. I also agree the turn back every so often to break the swarf, and actually remove the tap to wipe down the flues if required. Best regards James T Q2-002 (Still Pink) -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
