The drop down flaps are standard, the ones on mine were done by the cars
builder (not me).
The nose is standard though.
From memory there are 6 bolts, 4 through the front and 2 under the
wheel arches.
The main problem you are likely to have is the bolts that hold the
nosecone on, if they have rusted then they will be a pig to undo and
almost impossible to get an angle grinder at.
Have some spare bolts and nuts handy incase you have to cut any or they
shear off.
Jim
On 13/06/2010 13:59, Reading Al wrote:
Hi,
I have leaky radiator on my Q Saloon. After looking I guess I need to
remove the nose cone.
As I use the car as my daily drive and as I will be doing this in the
street I'm getting as much info as I can before hand.
After a bit of a root about on the web I found this picture of a nose
cone off of the car.
This nose is different to mine as I have the pop down flap rather than
pop up lights.
http://www.quantums.info/pictures/coupe/holes_in_my_nose.JPG
(Thanks to Jim Hearne!)
Are the bolts at positions 1 to 4 what I should be looking for?
The build manual I have mentions 4 bolts but the picture above shows 4
each side?
I actually think its only 1 and 2 as I haven't seen the others along
the front of the engine bay.
Many thanks,
Al
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
