The pads have not been changed, According to the paperwork the car has only done around 4500 miles since being converted and it would appear that new pads were fitted then, The tyre condition would also tend to reinforce that impression still appearing almost brand new. I did 3k of those miles in the few months I had the car on the road.
I was hoping to get the car on the road for this weekend and head up to the show. It would be good to meet some other owners. My car would also make everyone elses look much better. This project is a first for me as I have always been a 'throw it at a specialist' kind of car owner. I must be getting old now because I begrudge spending the money and quite fancy the satisfaction of driving something I have worked on myself. I last did that with a mkIII cortina 25 years ago. Mark On Jun 17, 10:20 am, Jim Hearne <[email protected]> wrote: > Not if nothing has been done to the brakes but if you'd changed the pads > recently it's easily done. > > Jim > > On 17/06/2010 10:01, taximark wrote: > > > > > And regards the spring clip, is that likely as the brakes were fine > > before the car was parked up? > > > Mark > > > On Jun 17, 9:35 am, Jim Hearne<[email protected]> wrote: > > >> Something seizing would normally make the pedal harder (but probably not > >> noticeably so). > >> I've had problems with rust in the master cylinder bore caused by water > >> sitting there. > >> This was with silicone brake fluid so the water stays separated and sits > >> at the lowest points in the system. > >> With normal brake fluid the water gets absorbed into the fluid and > >> shouldn't cause this problem. > > >> It could just be old fluid so try flushing it through with new first. > > >> Also, just a though, make sure the spring clip is fitted to the outside > >> of the front calipers, this missing gives a soft pedal. > > >> Jim > > >> On 17/06/2010 09:24, taximark wrote: > > >>> Hi Jon > > >>> I look forward to seeing the pics of this. My hood is going to have to > >>> wait for a while so hopefully it isn't going to be a wet summer. > > >>> I shall be spending the morning trying to find out why the brakes > >>> don't work very well. I have very litttle braking effort and the pedal > >>> is like pressing treacle, very spongy and soft. There is some braking > >>> effort but way short of any real use. I am guessing that something has > >>> probably siezed while the car has been parked up. If anyone has any > >>> suggestions they would be appreciated but I don't think a strip down > >>> and rebuild is going to do any harm to the brakes, after all they are > >>> kinda important. > > >>> Then this afternoon I will be fitting the exhaust and hopefully ** > >>> test drive time!! **. > > >>> Mark > > >>> On Jun 16, 11:01 pm, "jon jackson"<[email protected]> wrote: > > >>>> Hi I have just had a hood made by this man [email protected] > >>>> When the hood arrived I was amazed at how good it was and have to admit > >>>> that I have not fitted it yet. > >>>> You will need to use your old hoods front fixing bar as the new one is > >>>> left unattached at the front. > >>>> I will be doing a photo series for interested parties to see how its > >>>> done. > >>>> cheers Jon > > >>>> ----- Original Message ----- > >>>> From: Mark Miles > >>>> To: [email protected] > >>>> Sent: Tuesday, June 15, 2010 10:59 PM > >>>> Subject: Re: [Quantum Owners] 2+2 Paintwork > > >>>> Hi Jim, > >>>> When chatting to her I reiterated the accident several times in the > >>>> conversation and she confirmed that was the correct premium. I don't > >>>> know if it had any bearing but I have been a professional driver for > >>>> over 20 years and had almost a million miles claim free... > > >>>> As regards the body repairs you make it sound quite easy. I shall go > >>>> google for the gelcoat... I would prefer to do the work myself. > > >>>> I have to say that having seen the attention that driving this car > >>>> gets (and a previous kitcar (renault 4 Malibu) my ex wife owned) that I > >>>> am sorely tempted to throw away my hovercraft plans and buy a new kit to > >>>> build. I would also like to upgrade the engine to an RS turbo lump. > >>>> Having had the car for almost 2 years now and only driven it for 6 > >>>> months or so I can't wait to get it back on the road. It is on axle > >>>> stands at the moment awaiting a new exhaust for the MOT. I get a little > >>>> tingle every time I see it knowing that in a few days I will be able to > >>>> drive it again. > > >>>> Thanks for the advice. > > >>>> Mark > > >>>> --------------------------------------------------------------------------- > >>>> --- > >>>> From: Jim Hearne<[email protected]> > >>>> To: [email protected] > >>>> Sent: Tue, 15 June, 2010 22:39:18 > >>>> Subject: Re: [Quantum Owners] 2+2 Paintwork > > >>>> Hi Mark, > >>>> Welcome to the group. > > >>>> I suspect your local paintwork chappie isn't very familiar with > >>>> fibreglass cars. > >>>> I'd say gelcoat finish is easier to fix than a paint finish. > >>>> You just need to grind out any cracks and if they aren't deep just > >>>> fill > >>>> the cracks slightly proud with the correct colour gelcoat. > >>>> When it's set carefully sand the repairs back flush. > >>>> As long as you can match the colour it;s easy. > >>>> If the damage is deep then repair with mating and resin leaving the > >>>> area > >>>> slightly recessed and fil with gelcoat. > > >>>> If it's a common colour then the gelcoat can be obtained from many > >>>> boat > >>>> companies. > >>>> www.sailboats.co.ukisonei've used before. > > >>>> I'm afraid you may be disappointed on the insurance front, the > >>>> �175 only > >>>> applies if you have had no claims so you won't be eligible. > >>>> The woman at FJ should have known that. > > >>>> Jim > > >>>> On 15/06/2010 21:09, taximark wrote: > >>>> > Hi all, I have just joined the group and have been reading > >>>> through > >>>> > some of the posts. It appears that this is a very friendly and > >>>> helpful > >>>> > group. > > >>>> > A couple of years ago I bought a rather tired yellow 2+2. The > >>>> > paintwork is starred in a few places from what would appear to > >>>> be > >>>> > stone impacts and car park knocks. I understand that it is a > >>>> gel coat > >>>> > finish and my local paintwork chappie says that it is more > >>>> expensive > >>>> > to repair than to respray the whole car (which is double what I > >>>> paid > >>>> > for the car!). Does anyone have any suggestions on how I can > >>>> pretty > >>>> > this up without having to spend big bucks or spending a year at > >>>> > college to learn how to drive a paint sprayer. > > >>>> > I also made the mistake of leaving the car parked under a tree > >>>> for the > >>>> > last 18 months and am astonished at the damage that natures > >>>> finest > >>>> > have managed to do to the hood. I looked at the qsc website and > >>>> a new > >>>> > hood is loadsamoney, can anyone recommend someone reasonable > >>>> near > >>>> > Reading that might be able to make one for me. > > >>>> > Other than that I love my little car, It has the 1.4 engine but > >>>> is > >>>> > quick enough for me and returns almost 50 mpg at 65 mph. > > >>>> > The other thing that I was amazed about was insurance. I got a > >>>> quote > >>>> > from an insurance company this morning and was horrified at > >>>> �560. (no > >>>> > no claims discount as I have only been using my cab for years > >>>> and a > >>>> > knock with an audi last year). The girl at the insurance company > >>>> > suggested joining the owners club as the special rates brought > >>>> the > >>>> > premium down to just �175!! WOW, a �400 saving almost. My > >>>> cheque will > >>>> > be winging its way to the owners club forthwith. > > >>>> > Looking forward to getting to know you all. > > >>>> > Mark > > >>>> -- > >>>> You received this message because you are subscribed to the Google > >>>> Groups "Quantum Owners Group" group. > >>>> To post to this group, send email to [email protected] > >>>> To unsubscribe from this group, send email to > >>>> [email protected] > >>>> For more options, visit this group > >>>> athttp://groups.google.com/group/quantumowners?hl=en > > >>>> IMPORTANT NOTE: All information presented herewith is provided on an > >>>> "As Is" basis, without warranty or the implication thereof. Neither the > >>>> Quantum Owners Club nor the individuals associated with the Quantum > >>>> Owners Club or in the preparation of the above information shall have > >>>> any liability to any person or entity with respect to liability, loss, > >>>> or damage caused or alleged to be caused directly or indirectly by the > >>>> instructions contained within this or related message(s). > > >>>> -- > >>>> You received this message because you are subscribed to the Google > >>>> Groups "Quantum Owners Group" group. > >>>> To post to this group, send email to [email protected] > >>>> To unsubscribe from this group, send email to > >>>> [email protected] > >>>> For more options, visit this group > >>>> athttp://groups.google.com/group/quantumowners?hl=en > > >>>> IMPORTANT NOTE: All information presented herewith is provided on an > >>>> "As Is" basis, without warranty or the implication thereof. Neither the > >>>> Quantum Owners Club nor the individuals associated with the Quantum > >>>> Owners Club or in the preparation of the above information shall have > >>>> any liability to any person or entity with respect to liability, loss, > >>>> or damage caused or alleged to be caused directly or indirectly by the > >>>> instructions contained within this or related message(s). -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
