If the new pump has a longer travel then using it with less travel would just 
give you less fuel flow, not really an issue as long as it’s still enough fuel 
for full throttle.
Some engines didn’t use the return to the tank, they may have had less fuel 
flow.

My only worry would be if the new pump reaches the limit of it’s travel then 
something will break, the pump or the pushrod or maybe even the cambelt.
I would put in the new pushrod, turn the engine over by hand until it’s out 
it’s maximum distance.
Then push the new pump over the studs and make sure you can get the gap between 
the pump base and the head surface to less than the thickness of the spacer and 
gaskets.

Jim


From: teegee777 
Sent: Monday, September 09, 2013 10:38 AM
To: [email protected] 
Subject: [Quantum Owners] Re: 2+2 1.4 CVH mechanical fuel pump

I managed to work on the Quantum at the weekend. There was plastic pipe from 
sender to bottom of car, then short rubber hose to metal pipe and then rubber 
hose to pump at the front. I removed the rubber hose to metal connection near 
the tank and petrol flowed and I could blow through the metal pipe. I had some 
copper pipe from another project so re-piped car front to back. I reconnected 
everything and turned the engine over and I have never seen my "see through" 
petrol filter so full of petrol before and it starts fine. The only thing I can 
find is a bad chafing on the old metal pipe (see attached photo) it was 
touching the gearbox steady rod and managed to put a mark into the pipe. If you 
look closely you can see the oval mark of the inner wall,but I don't think it 
was leaking petrol?? All I have to do now is to decide whether to fit the new 
pump,can I damage anything if it is a longer stroke? or shall I try to pack out 
the difference, or was my old one to short? Thanks Tony

On Thursday, September 5, 2013 9:56:16 PM UTC+1, teegee777 wrote: 
  I'm having problems starting the 2+2, it has a 1.4 cvh engine with twin choke 
Weber and mechanical fuel pump. It always was a little difficult to start after 
a period of non use (6-7 days) but pumping the accelerator always got it going. 
The other week it refused to start and had been smelling of petrol, there was 
no fuel in the in-line clear fuel filter. I got it started by putting a fuel 
hose in a petrol can and after it started I found a leak in the return pipe 
from carb back to the tank, fixed this and everything had been fine. However it 
has now started to play up again, same symptoms, so ordered a new mechanical 
fuel pump. Now I have two issues.... The operating stud is about 4-5mm longer 
than the original fuel pump and it still isn't pumping up from the tank. Any 
ideas on packing /spaces for the new pump and what may be the problem at the 
tank end? I guess I may have to lay on the floor and have a look :o) Doesn't 
appear to be smelling of fuel anymore. If I prime it from the petrol can it 
will work (for ever),guess the engine running is better than pumping on the 
starter motor. Thanks Tony

-- 
-- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en
 
IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
--- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.

-- 
-- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
--- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.

Reply via email to