If the old pipe had even a minute pin hole, It would draw air throught it and hence not pull up any fuel. Be careful with the new pipe that you have fitted. I am sure I read somewhere that the latest E10 fuel will affect it over time - I could be wrong but it's worth checking.
Bob Craig >----Original Message---- >From: [email protected] >Date: 09/09/2013 10:53 >To: <[email protected]> >Subj: Re: [Quantum Owners] Re: 2+2 1.4 CVH mechanical fuel pump > >If the new pump has a longer travel then using it with less travel would just give you less fuel flow, not really an issue as long as it’s still enough fuel for full throttle. >Some engines didn’t use the return to the tank, they may have had less fuel flow. > >My only worry would be if the new pump reaches the limit of it’s travel then something will break, the pump or the pushrod or maybe even the cambelt. >I would put in the new pushrod, turn the engine over by hand until it’ s out it’s maximum distance. >Then push the new pump over the studs and make sure you can get the gap between the pump base and the head surface to less than the thickness of the spacer and gaskets. > >Jim > > >From: teegee777 >Sent: Monday, September 09, 2013 10:38 AM >To: [email protected] >Subject: [Quantum Owners] Re: 2+2 1.4 CVH mechanical fuel pump > >I managed to work on the Quantum at the weekend. There was plastic pipe from sender to bottom of car, then short rubber hose to metal pipe and then rubber hose to pump at the front. I removed the rubber hose to metal connection near the tank and petrol flowed and I could blow through the metal pipe. I had some copper pipe from another project so re-piped car front to back. I reconnected everything and turned the engine over and I have never seen my "see through" petrol filter so full of petrol before and it starts fine. The only thing I can find is a bad chafing on the old metal pipe (see attached photo) it was touching the gearbox steady rod and managed to put a mark into the pipe. If you look closely you can see the oval mark of the inner wall, but I don't think it was leaking petrol?? All I have to do now is to decide whether to fit the new pump,can I damage anything if it is a longer stroke? or shall I try to pack out the difference, or was my old one to short? Thanks Tony > >On Thursday, September 5, 2013 9:56:16 PM UTC+1, teegee777 wrote: > I'm having problems starting the 2+2, it has a 1.4 cvh engine with twin choke Weber and mechanical fuel pump. It always was a little difficult to start after a period of non use (6-7 days) but pumping the accelerator always got it going. The other week it refused to start and had been smelling of petrol, there was no fuel in the in-line clear fuel filter. I got it started by putting a fuel hose in a petrol can and after it started I found a leak in the return pipe from carb back to the tank, fixed this and everything had been fine. However it has now started to play up again, same symptoms, so ordered a new mechanical fuel pump. Now I have two issues.... The operating stud is about 4-5mm longer than the original fuel pump and it still isn't pumping up from the tank. Any ideas on packing /spaces for the new pump and what may be the problem at the tank end? I guess I may have to lay on the floor and have a look :o) Doesn't appear to be smelling of fuel anymore. If I prime it from the petrol can it will work (for ever), guess the engine running is better than pumping on the starter motor. Thanks Tony > >-- >-- >You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. >To post to this group, send email to [email protected] >To unsubscribe from this group, send email to quantumowners- [email protected] >For more options, visit this group at >http://groups.google.com/group/quantumowners?hl=en > >IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). >--- >You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. >To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. >For more options, visit https://groups.google.com/groups/opt_out. > >-- >-- >You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. >To post to this group, send email to [email protected] >To unsubscribe from this group, send email to quantumowners- [email protected] >For more options, visit this group at >http://groups.google.com/group/quantumowners?hl=en > >IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). >--- >You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. >To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. >For more options, visit https://groups.google.com/groups/opt_out. > -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
