Dear All, Just had one of the rear axle supports for the rear brake hose rust through and it now needs replacing. It would be good to not have to remove the rear axle to repair it.
I wondered what the thickness of metal of the rear axle is for welding purposes. Is it thin enough to use a medium size MIG welder on successfully rather than an arc welder? Anyone know? I am thinking about getting a new MIG welder as this is the second small welding job recently and I have a few projects in mind for the year ahead. Thanks Derek -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
