hi take a look through some of the older posts in the group:
https://groups.google.com/forum/#!searchin/quantumowners/bearing|sort:relevance/quantumowners/QKTtAaa5pTg/8U7XVgK5fbsJ https://groups.google.com/forum/#!searchin/quantumowners/bearing|sort:relevance/quantumowners/X2nYo1zYeCQ/-P56a3vPKCkJ in short, tighten them till they start to grip, then slacken off a bit. someone else did mine, but as per the first link above you do NOT tighten up to any ford level, they are a different type of bearing. cheers Chris On Thursday, 4 May 2017 11:43:05 UTC+1, robert greig wrote: > > Hello. Everyone. > > Got the Xtreame MOT done today and I have noisy front wheel bearings. > Looking at the build manual it just says tighten and check after 20 miles. > As the hub is not a Ford part. > > I am not able to replace these my self, so what torque setting should I > recommend to the garage that will do the work for me? > > > Regards Robert Greig > > -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
