Want to fit a set of bonnet catches to secure bonnet a bit firmer, requires 2 holes to be drilled , bonnet one is fine as have rear access , however on section between bonnet and door I am drilling blind and was wondering if anything is in behind panel. I recently removed side indicators & fibreglass appears to be between 8 & 10mm thick at that section, but lower lipped section at wheel arch seems not to sound as hollow , which is where ideally I would like to drill , anyone got any knowledge on this ?
Thanks Calum. -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
