Has your bonnet already got locating pins in each corner ? Those properly done should hold the corners of the bonnet quite securely. The default Quantum ones are rectangler furniture block on the body and matching holes in the flange of the bonnet. Unfortunately it’s quite hard to work out exactly where the hole should be so they are quite often oversize.
I didn’t use the plastic blocks, i fitted stainless pins into the body (about 1/2” dia”") with a taper on the end, and a large grommet into a hole in the bonnet. A self adhesive rubber seal around the rear of the bonnet will also help reduce the movement of the rear of the bonnet but if you’ve not got vents in the bonnet it might increase the temperature under the bonnet. Anyway, back to your original question, there is nothing inside that area except a void and the big steel box section where it kicks up from the sill. If you drill too close to the edge you may come through under the wheel arch. If you have the tools drill and tap the fibreglass rather than using self tapping screws. If you have to use self tappers then countersink the hole so that the gel coat is clear from around the edge, without that the screw will almost certainly crack away part of the gelcoat around the hole. Jim From: calum mcpherson Sent: Tuesday, June 13, 2017 12:45 PM To: Quantum Owners Group Subject: [Quantum Owners] Bonnet catches Want to fit a set of bonnet catches to secure bonnet a bit firmer, requires 2 holes to be drilled , bonnet one is fine as have rear access , however on section between bonnet and door I am drilling blind and was wondering if anything is in behind panel. I recently removed side indicators & fibreglass appears to be between 8 & 10mm thick at that section, but lower lipped section at wheel arch seems not to sound as hollow , which is where ideally I would like to drill , anyone got any knowledge on this ? Thanks Calum. -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
